Komatsu — 35.5 ADJUSTMENT OF AIR SUSPENSION SEAT

35. HANDLING AJSS (ADVANCED JOYSTICK STEERING SYSTEM) D : Setting seat for weight To protect the operator, it is necessary to adjust the suspension to match the operator's weight. Push lever 3 down to lower the seat to the lowest position, then pull lever 3 up fully (pull it until a click can be felt). When the lever is released, the weight adjustment is carried out automatically. To ensure that the weight adjustment is carried out correctly, the operator should sit in the normal operating position when operating the lever. If the operator raises his body from the seat or changes the amount of weight applied to the seat during adjustment, the air in the suspension may be discharged.

When operators change shifts, the new operator should push lever 3 down to lower the seat to the lowest position, then pull lever 3 up fully (pull it until a click it is felt). When the lever is released, the weight adjustment is carried out automatically. If lever 3 is pulled lightly, the weight adjustment starts, but always pull the lever up fully (pull it until a click is felt) before releasing it. REMARK When making initial adjustment or when adjusting the weight settings when operators change shifts, set the damping force of the suspension damper to the soft setting (for details, see "Adjusting hardness of suspension damper"), then adjust it to match the operator's weight.

If the damping force of the suspension damper is left set to the hard setting and the height of the seat is adjusted, even if the height is raised, the seat may go down. If the seat goes down, set the damping force of the suspension damper to the soft setting, lower the seat, then adjust the weight again. After completing adjustment of the weight and height, set the damping force of the suspension damper to the desired strength. To protect the operator, the suspension must be adjusted to match the operator's weight. Adjust the weight before starting operations. When adjusting, do not remove your weight from the seat or change the load in any other way.

If this is done, the air may be released from the suspension's seat. E : Fore-and-aft adjustment of seat cushion Operate lever 4 up, set the seat cushion to the desired position, then release the lever. Fore-and-aft adjustment: 60 mm (2.4 in) F : Adjusting reclining angle Operate lever 5 up and move the back cushion to the front or rear. But your back firmly against the seat back when carrying out this adjustment. If you move your back away from the seat back, the seat back may suddenly spring forward. Amount of adjustment Forward tilt: 20 degrees (over 20 degrees is free) Rear tilt:

60 degrees NOTICE If the seat back is reclined too far, the seat back may hit the rear glass, so use it in a position where it does not contact the glass. G : Adjusting headrest angle Rotate the backrest to the front or rear and set to the desired angle. Amount of adjustment: 38 degrees 5-60