Doosan GC20SC-5 — Doosan GC20SC-5 User Manual

Maintenance section Lubricant Specifications Lubricant Information Hydraulic Oil (HYDO) Certain abbreviations follow Society of Automotive Engineers (SAE) J754 nomenclature and some classifications follow SAE J183 abbreviations. The MILspecifications are U.S.A. Military Specifications. The recommended oil viscosities can be found in the Lubricant Viscosities chart in this publication. Grease is classified by the National Lubricating Grease Institute (NLGI) based on ASTM D217-68 Worked Penetration characteristics which are given a defined consistency number. Engine Oil (DEO and EO) The following commercial classifications can be used in the hydraulic system.

• ISO 6743/4 HM • AFNOR NFE 48-603 HM • DIN 51524 TEIL 2 H-LP • HAGGLUNDS DENISON HFO-HF2 • CINCINNATI P68,69,70 Viscosity : ISO VG32 Industrial premium hydraulic oils that have passed the Vickers vane pump test (35VQ25). These oils should have antiwear, antifoam, antirust and antioxidation additives for heavy duty use as stated by the oil supplier. ISO viscosity grade of 32 would normally be selected. NOTICE Make-up oil added to the hydraulic tanks must mix with the oil already in the systems. Use only petroleum products unless the systems are equipped for use with special products. If the hydraulic oil becomes cloudy, water or air is entering the system.

Water or air in the system will cause pump failure. Drain the fluid, retighten all hydraulic suction line clamps, purge and refill the system. Consult your DOOSAN Lift Truck dealer for purging instructions. The following oil specifications provide guidelines for the selection of commercial products : LP-Gas Engine : API SJ or higher NOTICE Failure to follow the oil recommendations can cause shortened engine lift due to carbon deposits or excessive wear. Consult the EMA Lubricating Oils Data Book for a listing of oil brands. NOTE : The percentage of sulfur in the fuel will affect the engine oil recommendations.

For fuel sulfur effects, the Infrared Analysis or the ASTM D2896 procedure can be used to evaluate the residual neutralization properties of an engine oil. The sulfur products formation depends on the fuel sulfur content, oil formulation, crankcase blowby, engine operating conditions and ambient temperature. 101