Maintenance section Every 3000 Service Hours or 18 Months You must read and understand the warnings and instructions contained in the Safety section of this manual, before performing any operation or maintenance procedures. Timing Belt - Change See the “Service Manual” for the procedure and specifications. Timing Belt for Counterbalance Shaft - Change See the “Service Manual” for the procedure and specifications. Every 4500 Service Hours or two Years Replace Oxygen Sensor (1) Oxygen Sensor 1. Stop engine and wait until the exhaust pipe and exhaust pipe is cooled. 1 2. Disconnect the electrical connector of oxygen sensor 3. Remove oxygen sensor 4.
Assemble new oxygen sensor Tightening torque : 45 N•m (32.5 lb•ft) 5. Connect the electrical connector of oxygen sensor 145