Safety Section Seat Belt The Operator Restraint System, Prevents the operator from jumping from the operator's compartment in the event of forward or side tipover. The system is designed to keep the operator on the seat and in the operator's compartment in the event of tipover. Inspection 3. In the event of tipover, the seat and restraint system should be inspected for damage and replaced, if necessary. NOTE: Operator restraints shall be examined at the regular truck service intervals. It is recommended that they be replaced if any of the following conditions are found: Cut or frayed strap Worn or damaged hardware including anchor points Buckle or retractor malfunction Loose stitching 1.
If the seat belt is torn, if pulling motion is interrupted during extension of the belt, or if the belt cannot be inserted into the buckle properly, replace the seat belt assembly. The seat belt may cause the operator to bend at the waist. If you are pregnant or have suffered from some abdominal disease, consult a doctor before you use the seat belt. Fasten the Seat Belt 1. Grip the plate (connector) of the belt and insert the plate into the slot of the buckle until a snap is heard. Adjust the belt to fit snugly acreoss your hips. Pull on the belt to confirm it is latched. 2. Make sure the belt is not twisted. 2. Belt Maintenance – Every 500 service hours.
Check that the belt fastening works properly and that winding device is free from run lock when jerked. Check that the belt is suitably fastened to the seat. Check that the seat is correctly secured to the hood and the chassis. On visual inspection, fastenings must be intact, otherwise, contact the safety manager. Your DOOSAN truck comes equipped with a DOOSAN operator restraint system. Should it become necessary to replace the seat for any reason, it should only be replaced with another DOOSAN operator restraint system. 20 WARNING WARNING