Operation Section 7. To change the lift truck direction of travel, release the accelerator pedal. Inching NOTE : The purpose of the inching pedal is to provide precise lift truck inching control at very slow travel speed and high engine rpm. This is used for fast hydraulic lift, during load approach, pick up or load positioning. 1. To inch (creep) in either direction, slowly push down on the inching pedal. This will start to apply the service brakes and allow the transmission clutch discs to slip. 8. Push down on the service brake pedal to reduce the lift truck speed as necessary. 9. Move the directional lever to the desired direction of travel.
Slowly push down on the accelerator pedal as the lift truck changes direction. 2. Vary the position of the inching pedal and the accelerator pedal to control the inching speed and distance. 3. Pushing down further on the inching pedal will disengage the transmission completely and apply the service brakes fully to stop and hold the lift truck. This will provide full engine power for fast hydraulic lift. 10. When the direction change is completed, continue to push down on the accelerator pedal to obtain the desired travel speed. 11. To stop the lift truck when traveling in either direction, release the accelerator pedal. 12.
Push down on the service brake pedal and bring the lift truck to a smooth stop. 82