Operation Section Transportation Hints Lift Truck Shipping Machine Lifting and Tiedown Information Check travel route for overpass clearances. Make sure there is adequate clearance if the lift truck being transported is equipped with a high mast, overhead guard or cab. To prevent the lift truck from slipping while loading or shifting in transit, remove ice, snow or other slippery material from the loading dock and the truck bed before loading. NOTICE Obey all state and local laws governing the weight, width and length of a load. Observe all regulations governing wide loads. NOTICE Remove ice, snow or other slippery material from the shipping vehicle and the loading dock.
Always block the trailer or the rail car wheels before loading the lift truck. Position the lift truck on the truck bed or the rail car. Apply the parking brake and place the directional control lever in NEUTRAL. Turn the ignition switch to the OFF position and remove the key. If LP-Gas equipped, shut off the LP Gas fuel tank. Block the wheels and secure the lift truck with tiedowns. NOTICE Improper lifting or tiedowns can allow load to shift and cause injury and/or damage. 1. Weight and instructions given herein apply to lift trucks as manufactured by DOOSAN. 2. Use proper rated cables and slings for lifting. Position the crane for level lift truck lift. 3.
Spreader bar widths should be sufficient to prevent contact with the lift truck. 4. Use the tiedown locations provided for lift truck tiedown. Check the state and local laws governing weight, width and length of a load. Contact your DOOSAN Lift Truck dealer for shipping instructions for your lift truck. 90