During the first 10 hours of operation, always use less than Ѕ throttle. Varying the engine RPM during the break-in period allows the components to “load” (aiding the engine/transmission compo- nent mating process) and then “unload” (allowing components to cool). Although it is essential to place some stress on the engine components during break-in, care should be taken not to overload the engine too often. Do not pull a trailer during the break-in period. ATV0049D Allow the engine to cool before filling the gas tank. Care must be taken not to overfill the tank. If overfilled, gas may leak onto the engine creating a fire hazard. When the engine starts, allow it to warm up properly.
Idle the engine several minutes until the engine has reached normal operat- ing temperature. Do not idle the engine for excessively long periods of time. ! WARNING Do not over-flow gasoline when fill- ing the gas tank. A fire hazard could materialize. Always allow the engine to cool before filling the gas tank. Brakes Brake pads must be burnished to achieve full braking effectiveness. Braking dis- tance will be extended until brake pads are properly burnished. To properly burnish the brakes, use following procedure: ! WARNING Do not overfill the gas tank. Tighten the gas tank cap securely after filling the tank.
Break-In Procedure After the completion of the break-in period, the engine oil and oil filter should be changed. Other maintenance after break-in should include checking of all prescribed adjustments and tightening of all fasteners. At the discretion and expense of the owner/operator, the ATV may be taken to an authorized Arctic Cat ATV dealer for this initial service. CAUTION TO PROPERLY BURNISH THE BRAKES, USE FOLLOWING PROCE- DURE: Choose an area sufficiently large to safely accelerate ATV to 30 mph and to brake to a stop. Accelerate to 30 mph; then press the brake pedal to decelerate to 0-5 mph. Repeat procedure twenty times. Engine !
WARNING Do not attempt sudden stops or put yourself into a situation where a sudden stop will be required until the brake pads are properly bur- nished. New ATV’s and renewed ATV engines require a “break-in” period. The first month is most critical to the life of this ATV. Proper operation during this break- in period will help assure maximum life and performance from the ATV. 44