Scania — Fitting

Engine Ch 1 page 122 Fitting 1. Lubricate the main bearings and place them in the block. 2. Lift in the crankshaft. 3. Insert the main bearings in the crankshaft bearing caps and fit them. Note: Fit the main bearings and caps in the same place as before removal. NOTE the machine serial number! 4. Machine 810001 - 810108 Tighten the bearing cap bolts to 50 Nm + 90°. 4. Machine 810109 (Tier3) - Tighten the bearing cap bolts to 200 Nm + 90°. 5. Fit the pistons with connecting rods as described in Fitting the connecting rod and piston. 200 Nm +90° 6. Fit the oil pump, oil suction pipe with strainer and the oil sump. 7. Renew the seal in the front cover.

Fit the spacing sleeve on the crankshaft journal. Fit the driver and crankshaft damper. See Belt transmission, Renewing the seal in the front cover. 90° 8. Fit the crankshaft gear as described in Crankshaft gear, fitting. SHOP MANUAL MT41 - 12.2004