Engine Ch 1 page 131 Dismantling and assembly - During routine cleaning of the oil cleaner, there should be a certain amount of dirt deposits in the rotor bowl. - If this is not the case, it indicates that the rotor is not spinning. The cause of this must be immediately investigated. - If the dirt deposit exceeds 28 mm at the recommended intervals, the rotor bowl should be cleaned more often. 1. Undo the nut holding the outer cover and remove the nut. 2. Drain out the oil from the rotor 3. Lift out the rotor. Wipe off the outside. Undo the rotor nut and unscrew it about three turns to protect the bearing. Note: The rotor must not be put in a vice. Never strike the rotor bowl.
This may cause damage resulting in imbalance. 4. If the rotor nut is difficult to get loose, turn the rotor upside down and fasten the rotor nut in a vice. 5. Turn the rotor counterclockwise 1,5 turns by hand, or if this does not help, use M20 screw and nut as shovn at the figure SHOP MANUAL MT41 - 12.2004