Scania — Pistons and cylinder liners

Engine Ch 1 page 151 Turbocharger Wear limits Shaft radial clearance. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 0.198-0.564 mm Shaft axial clearance (after running in) . . . . . . . . . . . . . . . . . . . . . . . . . . . . 0.025-0.106 mm Tightening torques Bolts, turbocharger - exhaust manifold . . . . . . . . . . . . . .. . . . . . . . . . . . . . .63 Nm Bolts in turbine housing (exhaust pipe) . . . . . . . . . . . . . . . . . . . . . . . . . . . . 24 Nm V-clamps, exhaust and intake . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6-10 Nm Pistons and cylinder liners Cylinder liner Shims for cylinder liner, thickness. .. . . .

. . . . . . . . . . . . . . . . . . . . . . . . . . . 0.20, 0.25, 0.30, . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .. . . . . . . . . . . . . . . . .. . . . 0.40, 0.50, 0.75 mm Height of cylinder liner above cylinder block . . . . . . . . . . . . . . . . . . . . . . . 0.20 - 0.30 mm Maximum permitted height difference on one liner between dimensions measured at two diametrically opposite points. . . . . . . . . . . 0.02 mm Pistons Fitted with arrow on piston crown facing forward. Piston rings Number of compression rings . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 Gap: 1st ring . . . . . . . . . . . . . . . . . . . . . . . .

. . . . . . . . . . . . . . . . . . . . . . . . . . . 0.35 - 0.60 mm 2nd ring. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 0.45 - 0.65 mm Maximum clearance in groove, 2nd ring . . . . . . . . . . . . . . . . . . . . . . . . . . . 0.25 mm Rings marked “TOP” should be turned with the marking up. Number of oil scraper rings . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1 Gap . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 0.40 - 0.65 mm Max. clearance in groove. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

. . 0.25 mm SHOP MANUAL MT41 - 12.2004