Engine Ch 1 page 80 Renewal of bearing bushing in connecting rod Use tool 512564 when renewing the bearing bushing. The tool comprises three parts: 1. Pressplate with guide pin 2. Press drift 3. Supports There are different supports, depending on the engine type. The support marked with a D should be used for the 12engine. Important! Before carrying out this procedure, the connecting rod should be checked for straightness in accordance with Checking connecting rods Work description 1. Fit the correct support on the pressplate and place the connecting rod so that the wide end of the connecting rod is resting against the support.
Turn the press drift with the smaller diameter against the bearing bushing and press it out. 2. Turn over the press drift and mount a new bearing bushing onto it. Press in the bearing bushing. SHOP MANUAL MT41 - 12.2004