Scania — Pistons

Engine Ch 1 page 83 The bowl-shaped combustion chamber in the piston crown has a protuberance in the centre. The design of this pro­ tuberance ensures that the fuel injected at the end of the compression stroke is quickly mixed with the air in the com­ bustion chamber. Piston rings For the piston to travel freely, a gap is required between the piston and cylinder liner. The piston therefore has two compression rings which seal this gap and conduct the heat from the piston. The upper of these rings is exposed to higher pres­sure than the intermediate ring and is therefore wedge-shaped, a “keystone” ring, which increases the force pressing it against the cylinder wall.

Since the greatest stress is on the upper piston ring groove, and also to reduce wear, a reinforcement of cast iron is incorpo­ rated in the piston. The bottom piston ring, the oil scraper ring, pre­vents oil from the crankcase from finding its way up to the combustion cham­ ber. In the oil scraper ring is a coil spring which presses it against the cylinder wall. The design and quality of the pistons and piston rings are ex­ tremely important for the reliability and lubrication of the engine as well as oil and fuel consumption. SHOP MANUAL MT41 - 12.2004