Scania — Removing the flywheel housing

Engine Ch 1 page 95 Renewing the rear crankshaft seal 1. Remove the crankshaft seal using a screwdriver. Take care not to scratch the sealing surfaces on the crankshaft and the flywheel housing. Note: The crankshaft seal must be fitted dry and must not be lubricated. The sleeve in the seal should be left in place until the seal is fitted. The crankshaft should be degreased before the new seal is fitted. 2. Fit the new crankshaft seal using tool 512555. Place the crankshaft seal on the tool and fasten the tool with the bolts. 3. Turn the tool clockwise until is stops in order to attain the correct crankshaft seal position. Removing the flywheel housing 1. Remove the starter motor. 3.

Remove flywheel housing. SHOP MANUAL MT41 - 12.2004