volvo — Volvo Trucks Service Manual Group 177-500

Group 170 Preventive Maintenance Check Engine Controls and Performance Note: For further information refer to literature in Func- tion Group 3. Check engine controls and performance while moving through the gears. Accelerator pedal should work smoothly and without any hesitation in engine response. Engine should accelerate smoothly and without hesita- tion, misses or surges. Also check the exhaust through the mirrors for excessive smoke during acceleration. During acceleration in a low gear, let engine go to full speed on a flat stretch of road. Note maximum engine speed. Check each engine manufacturer’s specifications for correct speed. Check Engine Brakes Note:

For further information refer to literature in Func- tion Group 3. When operating a tractor bobtail without a trailer or on slippery roads, the engine brake switch must be in the position. Failure to follow these instructions can result in loss of vehicle control and serious personal injury or death. If the engine is equipped with an exhaust brake (only on Volvo) or an engine brake, check the effectiveness of the retarding force when the brake is engaged. Engine Brake (D12) The engine brake has two operation modes, high and low, that are selected by one or two switches on the dashboard. Make sure the brake function disengages by: Either depressing accelerator or clutch pedal.

Engine speed goes under 1000 rpm (1000 r/min). Vehicle speed goes under 2 mph (3 km/h). Turbo boost pressure going over 50 kPa (7 psi) Engaging PTO. Engaging ABS. 90