SERIES 40 ENGINE OPERATOR'S GUIDE To avoid injury from contact with the contaminants in used engine oil, wear protective gloves and apron. To avoid injury from hot surfaces, allow engine to cool before removing any component. Wear protective gloves. To avoid injury from slipping and falling, immediately clean up any spilled liquids. To avoid injury, use care when working around moving belts and rotating parts on the engine. To avoid injury from the expulsion of hot coolant, never remove the cooling system pressure cap while the engine is at operating temperature. Remove the cap slowly to relieve pressure.
Wear adequate protective clothing (face shield or safety goggles, rubber gloves, apron, and boots). To avoid injury from contact with rotating parts when an engine is operating with the air inlet piping removed, install an air inlet screen shield over the turbocharger air inlet. The shield prevents contact with rotating parts. All information subject to change without notice. (Rev. May 2004) 5 DDC-SVC-MAN-0057 0305 Copyright © 2003 DETROIT DIESEL CORPORATION