MAN — Man Series 40 Engine Operator's Guide

SERIES 40 ENGINE OPERATOR'S GUIDE Avoid Unnecessary Idling 2. Allow the engine to run between idle and 1000 rpm with no load for four or five minutes. This allows the engine to cool and permits the turbocharger to slow down. After four or five minutes, shut down the engine. Whenever possible, avoid unnecessary idling. During long engine idling periods with the transmission in neutral, the engine coolant temperature may fall below the normal operating range. The incomplete combustion of fuel in a cold engine will cause crankcase oil dilution, formation of lacquer or gummy deposits on the valves, pistons, and rings, and rapid accumulation of sludge in the engine.

When prolonged idling is necessary, maintain at least 850 rpm spring/summer and 1200 rpm fall/winter. Shutdown Warning Light and Buzzer Vehicles may be equipped with an automatic engine shutdown system that will stop the engine in the event of high coolant temperature, low coolant level, or low engine oil pressure. The SEL (stop engine light) and alarm buzzer and light on the instrument panel alert the operator of high coolant temperature, low coolant level, or low oil pressure conditions. Should temperature or pressure continue to change beyond the warning point to a predetermined level, the engine will automatically shut down.

Stopping the Engine Normal Stopping Stop an engine under normal operating conditions as follows: 1. Reduce engine speed to idle and put all shift levers in the neutral position. NOTICE: To avoid engine damage when the override feature is selected, the engine should be run no longer than is absolutely necessary. NOTICE: Stopping a turbocharged engine immediately after high-speed operation without allowing a sufficient cool-down period may cause damage to the turbocharger, as it will continue to turn without an oil supply to the bearings. All information subject to change without notice. (Rev. May 2004) 27 DDC-SVC-MAN-0057 0305 Copyright © 2003 DETROIT DIESEL CORPORATION