MAN — Man Series 40 Engine Operator's Guide

LUBRICATION AND PREVENTIVE MAINTENANCE INTERVALS Item 4 – Cooling System Coolant Inhibitors NOTICE: Coolant must be inhibited with the recommended SCA's (supplemental coolant additives) listed in this guide. In addition, the engine can be equipped with a coolant filter/inhibitor system as an installed option or as an after-sale item. Failure to check and maintain SCA levels at required concentrations will result in severe damage (corrosion) to the engine cooling system and related components. To avoid injury from the expulsion of hot coolant, never remove the cooling system pressure cap while the engine is at operating temperature. Remove the cap slowly to relieve pressure.

Wear adequate protective clothing (face shield or safety goggles, rubber gloves, apron, and boots). Coolant Level The cooling system must be full for proper operation of the engine. Check the coolant SCA (supplemental coolant inhibitors) at the intervals listed in Table 28. The inhibitors in antifreeze solutions must be replenished with a non-chromate corrosion inhibitor supplement when indicated. Refer to section G. How to Select Coolant for required inhibitor levels. With the engine stopped, check the coolant level daily and maintain it near the bottom of the filler neck on the radiator. On some installations this is done by checking an overflow bottle or sight glass.

Add coolant as required, but do not overfill. Before adding coolant, refer to section G. How to Select Coolant in this guide. Make a daily visual check for cooling system leaks. Look for an accumulation of coolant when the engine is running and when it is stopped. Coolant leaks may be more apparent on a engine when it is cold. Coolant Drain Interval Detroit Diesel recommends replacing coolant at the intervals listed in Table 21. 58 All information subject to change without notice. (Rev. May 2004) DDC-SVC-MAN-0057 0305 Copyright © 2003 DETROIT DIESEL CORPORATION