SERIES 40 ENGINE OPERATOR'S GUIDE NOTICE: Item 10 Lubricating Oil Filter Do not allow the air inlet restriction to exceed 20 inches of water (5.0 kPa) under any engine operating conditions. A clogged air cleaner element will cause excessive intake restriction and a reduced air supply to the engine. This, in turn, can result in increased fuel consumption, inefficient engine operation and reduced engine life. To avoid injury from slipping and falling, immediately clean up any spilled liquids. Install new spin-on oil filters whenever the engine oil is changed. Oil change intervals are listed in Table 20. Refer to section C. How to Replace the Lube Oil Filter for procedure.
See Figure 16 for typical filter installation. Inspect the entire air system for leaks daily. Look especially for torn air inlet piping or boots and loose or damaged clamps. Have worn or damaged parts repaired or replaced, as required. Retighten loose connections. Air Cleaner Replacement Dry type air cleaner elements should be replaced after one year of service or when the maximum allowable air intake restriction has been reached, whichever comes first. Refer to section J. When to Service the Dry Type Air Cleaner in this guide for additional information. 1. Oil Cooler Assembly 3. Oil Filter Header 2.
Oil Filter Figure 16 Typical Oil Filter Installation All information subject to change without notice. (Rev. May 2004) 63 DDC-SVC-MAN-0057 0305 Copyright © 2003 DETROIT DIESEL CORPORATION