MAN — Man Series 40 Engine Operator's Guide

SERIES 40 ENGINE OPERATOR'S GUIDE Replace Spin-On Type Oil Filter 3. Dispose of used oil and filter in an environmentally responsible manner, according to federal (EPA) and/or state recommendations. To avoid injury from slipping and falling, immediately clean up any spilled liquids. 4. Clean the filter gasket-contact surface of the adaptor head with a clean, lint-free cloth. 5. Fill the new filter with clean lubricating oil and lightly coat the filter gasket with the same oil. Replace spin-on type filter as follows: 1. Place a suitable container under the engine oil pan, remove the drain plug and drain the lubricating oil. Replace the drain plug and tighten securely. NOTICE:

Do not overtighten filters. Overtightening may crack or distort the filter adaptor. 2. Remove spin-on filter using tool J 29917 or equivalent and a 1/2-in. drive socket wrench and extension. See Figure 24. 6. Start the new filter on the adaptor head and tighten by hand until the gasket touches the mounting adaptor head. Tighten filter an additional one full turn by hand, or as indicated on the filter. 7. Add oil as required to bring the level to the “Full” or “Operating Range” mark on the dipstick. Refer to Item 1 – Lubricating Oil. 1. Oil Filter 2. Oil Filter Header Figure 24 Removing Oil Filter All information subject to change without notice. (Rev.

May 2004) 77 DDC-SVC-MAN-0057 0305 Copyright © 2003 DETROIT DIESEL CORPORATION