. OPERATION TRANSPORTATION HOLD NOTICE 3 - 117 The machine can b e lifted only if it has ho ok mark l abels. When lifting the ma chine, stop the machin e on leve l ground 1. Start the engin e, make sure tha t the machine is then set the wo rk equipment t o the tra vel posture. For details, see "MOVING TH E MACHINE (PAGE 3-90) (A): 40 - 50 cm 2. Check that the work equipme nt c ontr ol lever is at the H position, then s et the work equipment lock leve r to position. 3. Stop the engin e, check that t he area around the compartment is safe, then lock with th e frame l ock bar s the front frame and rear frame do not articulate 4.
Use wire ropes and slings that match t he weigh t of the machine, and wind the wire r ope and fix it to the lifting points as show n in the figure. Use protectors, etc . so that the wire ropes wi ll not be b roken at s Use threaders and bars having sufficient wid th so that the slings and wire ropes will not touch th For machines equi pped with a rear full fende r, remove the rear fu ll fender before carrying out the 5. After setting the wire ropes, lift up the m achine a nd stop at 100 to 200 mm (3.9 to 7.9 i n) above the ground, and check that the wire ropes are not slack and the machine is level, then lift up slowly.