. MAINTENANCE SERVICE PROCEDURE CHECK BATTERY ELECTROLYTE LEVEL Carry out this procedure before operating the machine. WARNING the UPPER LEVEL line. If the 3. If the electrolyte level is below the midway point between the U.L and L.L lines, remove cap (1) and add distilled water to the U.L line. 4. If distilled water has been added to any cell of cap (1), add distilled water also to the other cells. 5. Clean the vents of the battery caps, then close the caps securely. Keep the top of the battery clean and wipe it with a wet cloth. U.L. line.
Neutralize the 4 - 41 EVERY 250 HOURS SE RVICE Maintenance for every 50 an d 100 hours service should be carried out at the same tim Do not use the battery if the b attery electrolyte level is below the LOWER LEVEL line. This will inside of the battery and redu ce the service life of the battery. In addition, it may cause an exp The battery generates flamma ble gas and there is danger of explosion, do not bring fire or sp Battery electrolyte is dangero us. If it gets in your eyes or on your skin, wash it off with a large doctor.
When adding distilled water to the battery, do not allow the battery electrolyte to go above electrolyte level is too high, it may leak and cause damage to the paint surface or corrode oth NOTICE If there is a fear that the battery w ater may freeze after refilling with purified water (e.g. commercially for a battery), do the replenishm ent before the day's work on the next day. Inspect the battery electrolyt e level at least once a month and follow the basic safety p WHEN CHECKING ELECTROLYTE LEVEL FROM SIDE OF BATTERY If it is possible to check the e lectrolyte level from the side of the battery, check as follo 1. Open the cover of the battery box. There are two battery boxes:
One on each side at the rear of the machine. 2. Use a wet cloth to clean the area around the electrolyte level lines and check that the electrolyte level is between the UPPER LEVEL (U.L.) and LOWER LEVEL (L.L.) lines. If the battery is wiped with a dry cloth, static electricity may cause a fire or explosion. REMARK If distilled water is added to above the U.L. line, use a syringe to lower the level to th removed fluid with baking sod a (sodium bicarbonate), then flush it away with a large am Komatsu distributor or batter y maker.