Komatsu — EVERY 2000 HOURS SERVICE

. MAINTENANCE SERVICE PROCEDURE CHANGE OIL IN HYDRAULIC TANK, REPLACE HYDRAULIC FILTER ELEMENT WARNING immediately after the engine is stopped, and may cause burns. Wait for the 4 - 56 EVERY 2000 HOURS SERVI Maintenance for every 50, 100, 25 0, 500 and 1000 hours service should be carried out at t The parts and oil are at high tem temperature to go down before star When removing the oil filler cap, tur Refill capacity: 58 liters (15.32 U 1. Lower the bucket horizontally t o the ground and apply the parking brake, then stop the 2. Remove covers (1) and (2). Keep grip (3) pulled, then 3. counterclockwise and remove 4. Set a container to catch the oil 5. Loosen drain plug (P), drain th again.

6. Using a filter wrench, turn cartr 7. Clean the filter holder, fill the n coat the seal and thread of the thinly with grease) and install. When installing the seal, tighte contact with the filter holder, th 8. Refill the specified quantity of 9. Check that the hydraulic oil is at see "CHECK OIL LEVEL IN (PAGE 4-40)". 10. Run the engine at low idle, and bucket, and lift arm cylinders operate the cylinder to the end mm (3.9 in) before the end of s NOTICE f the engine is run at high speed immed iately after startup or a cylinder is pushed up to its stroke end, ai r taken inside the cylinder may cause damage to the piston packi ng. 11.

Operate the steering, bucket, a nd lift arm cylinders to the end of their stroke 3 to 4 time s, then stop the engine and loosen filler cap to bleed t he air from the hydraulic tank. vel and add oil to the specified level. For details, see "CHECK OIL LEVEL IN (PAGE 4-40)". 12. Check that the hydraulic oil le HYDRAULIC TANK, ADD OIL 13. Next, raise the engine speed a nd follow the procedure in Step 11 to bleed the air. Repe at this process until no more air comes out. operation, install cover (1) and (2). 14. After completing the air bleed