Komatsu — EVERY 2000 HOURS SERVICE

. MAINTENANCE SERVICE PROCEDURE REPLACE HST DRAIN FILTER WARNING and may cause burns. Wait for the 1. Remove cover (1). NOTICE 4 - 58 The temperature to go down before s When removing the oil filler cap, turn it slowly to release the internal pressure, the 2. Using a filter wrench, turn filt er cartridge (2) to the left to remo it. 3. Install the new filter cartridg Bring the packing surface in to contact with the seal surface the filter holder, then tighten 3/4 turns. .6 Nm (1.2 - 1.6 kgm) Tightening torque: 11.7 - 15 4. Check that the hydraulic oil i s at the specified level. For detai see "CHECK OIL LEVEL I (PAGE 4-40)". N HYDRAULIC TANK, ADD O 5.

Run the engine at low idle, and extend and retract the steering, bucket, a nd lift arm cy linders 4 to 5 time s. Be careful not to operate the cyl inder to the end of its stroke (sto p approx. 100 mm (3.9 in) b efore the end of st roke). If the engine is run at high speed im mediately after startup or a cylinder i s pushed u p to its stroke end, a ir taken inside the cy linder may cause damage to the piston pa 6. Operate the steering, bucke t, and lift arm cylinders to the en d of their stroke 3 to 4 tim es, then stop the e ngine and loosen filler cap to blee d the air from the hydraulic tank 7. Check that the hydraulic oi etails, TANK, ADD OIL (PAGE 4-4 8. After completing the air ble