Komatsu — EVERY 2000 HOURS SERVICE

. MAINTENANCE SERVICE PROCEDURE REMARK Carry out the check within 2 minutes after stopping the engine. If the machine is left with the engine stopped, the accumulator pressure will drop and it will be impossible to check the cause of the problem. your Komatsu distributor for inspection or 4 - 62 CHECKING FUNCTION OF A For details of handling the accum ulator, see Section "ACCUMULATOR (PAGE PPC ACCUMULATOR If the engine stops with the work e quipment raised, and it is impossible to start th e engine ag ain, it is possible as an emergency measure to actuate equipment to the ground. 1. Apply the parking brake. 2. Raise the work equipment operate the lift arm control le 3. Stop the engine. 4.

Leave the work equipment lo 5. Check that the area around t the lift arm control lever to F work equipment to a point 1m 6. When the lift arm comes to th control lever to LOWER po equipment slowly to the grou the valve with the oil pressure stored in the accumulator and lower the work to the maximum height, then ver to HOLD position (b). ck lever in the FREE position. he machine is safe, then operate LOAT position (d) and lower the above the ground. e 1m position, return the lift arm sition (c), and lower the work nd.

accumulato If the work equipment stops while it is moving, the gas pressure in the a ccumulator has pro Please contact your Komatsu dis Replace the accumulator every 4 CHECK ALTERNATOR, STA The brush may be worn or have repair. If the engine is started frequently , carry out inspection every 1000 hours CHECK ENGINE VALVE CLE ARANCE, ADJUST As special tool is required for rem oving and adjusting the parts, request your K omatsu distri butor for service CLEAN AND CHECK TURBO CHARGER If there is carbon or oil sludge stuc k to the blower impeller, it will lower the performance of the turbocharger or cause it to break, so ask your Komatsu distributor to carry out the cleaning.

CHECK VIBRATION DAMPER r peeling in the outside surface of the rubber. Check that there are no cracks o r peeling in the outside surface of the r If any cracks or peeling are found , contact your Komatsu distributor to h ave the parts replac