Maintenance—Every 4000 Hours Change Hydraulic Tank Oil, Clean Suction Screen NOTE: Change original factory fill hydraulic oil after first 4000 hours. Change every 4000 hours thereafter if using Super EX 46HN, if using premium AW46 oils change every 2000 hours thereafter. T6811AJ —UN—18OCT88 IMPORTANT: Prevent damage to hydraulic system components. DO NOT run engine without oil in the tank. Avoid mixing different brands or types of oils. Oil manufacturers engineer their oils to meet certain specifications and performance requirements. Mixing different oil types can degrade lubricant and machine performance. This excavator is factory filled with 46HN extended life zinc-free hydraulic oil.
Avoid servicing this excavator with products that do not meet this specification. If oils have been mixed or if alternate service oils are desired, the complete hydraulic system needs to be totally flushed by an authorized dealer. T135008 —UN—01NOV01 1. Park machine on level surface with upperstructure rotated 90° for easier access. 2. Position machine with arm cylinder fully retracted and bucket cylinder fully extended. 1— Hydraulic Oil Cap 2— Hydraulic Oil Tank Cover 3. Stop engine. VD76477,000010C -19-29JUN06-1/5 CAUTION: High pressure release of oil from pressurized system can cause serious burns or penetrating injury. The hydraulic tank is pressurized. DO NOT remove hydraulic cap.
Relieve pressure by SLOWLY loosening cap. 4. Insert 4 mm hex wrench (4) into hole (5) and turn counterclockwise to release locking pin. 5. Slowly turn cap (1) counterclockwise a few degrees to relieve pressure. Remove cap. Specification Hydraulic Tank—Oil Capacity....................................................................... 280.0 L (74.0 gal) 1— Cap 2— Aligning Marks 3— Case Assembly 4— Hex Wrench 5— Hole T135189 —UN—06NOV00 Continued on next page VD76477,000010C -19-29JUN06-2/5 3-11-1 060313 PN=111