Miscellaneous—Machine Diagnostic Display Unit (DDU) Operation The Diagnostic Display Unit (located in battery compartment) will show only codes produced by sensors on the engine and connected to the engine control unit (ECU). 4 5 6 Service codes are displayed according to J1939 Standard as a two part code. T139865 —UN—20MAR01 1 The first part of the code is a two—four digit Suspect Parameter Number (SPN), indicating the system or component having a failure; for example SPN 110 indicates a failure in the engine coolant temperature circuit.
3 2 T139865 The second part of the code is a two digit Failure Mode Identifier (FMI), indicating the type of failure that has occurred; for example FMI 3 indicates value above or below normal. 1— Diagnostic Display Unit 2— Down Arrow 3— Up Arrow 4— Yellow Indicator Light 5— Red Indicator Light 6— Display Window Code SPN 110 FMI 3 indicates engine coolant temperature too high. The diagnostic display unit will show active codes and stored codes, and can clear codes from memory after a repair has been made.
Active codes are occurring at the present time, and will be indicated by “SrvcCode” with dashes above it flashing on the display every 5 seconds or “Error” will appear in the display with the circuit causing the service code. The service code must be repaired and cleared to stop “SrvcCode” and “Error” from appearing in the display. If the service code is cleared without being repaired, it will reappear. Stored codes have occurred in the past. An intermittent short or open will cause a code to be stored. SPN and FMI code numbers will identify the circuit generating the code. A stored code can be cleared, but will reappear if the problem returns.
The diagnostic display unit will display real time temperatures, pressures and other items useful in diagnosing problems or monitoring operation of engine related items. Items displayed are listed below. SrvcCode (active service codes) StorCode (stored service codes) Units (choose English or Metric) EngConf Throttle % (measurement of voltage from engine speed dial Load@RPM Eng RPM (engine speed) EngHrs (total engine hours) CoolTmp (coolant temperature) FuelRate (fuel consumption in gallons per hour) ManiTmp (intake manifold air temperature) BatVolt (battery system voltage) Continued on next page TX14740,0001D21 -19-21MAY07-1/15 4-1-3 060313 PN=116