John Deere 450CLC Excavator — Install Boom, Arm, Bucket and Counterweight

Miscellaneous—Machine Assembly 4. Install the thick shim on the inside of each cylinder head end. Install shims (B), as required. Do not shim gap tighter than 0.5 mm (0.019 in.). Specification Shim—Gap.................................................................. 0.5 mm (0.019 in.) 5. Install pins and cap screws. Tighten cap screws. T6912AB —UN—28OCT88 B—Shim TX,111,DY2446 -19-31MAY01-4/19 6. Slowly remove hydraulic tube caps and connect hoses (A—D). A—Right Boom Cylinder Head End B—Right Boom Cylinder Rod End C—Left Boom Cylinder Head End D—Left Boom Cylinder Rod End T6912AC —UN—28OCT88 TX,111,DY2446 -19-31MAY01-5/19 CAUTION: The approximate weight of boom pivot pin is 116 kg (257 lb).

Specification Boom Pivot Pin—Weight......................................................................116 kg (257 lb) 7. Remove retainer to slide pin out. T5856AS —UN—27OCT88 CAUTION: The approximate weight of boom and arm cylinder is 3370 kg (7,430 lb). Specification Boom And Arm Cylinder—Weight........................................................ 3370 kg (7,430 lb) 8. Lift boom into position, install pin. Install shims, as required, on each side of boom. Continued on next page TX,111,DY2446 -19-31MAY01-6/19 4-2-2 060313 PN=134