John Deere 450CLC Excavator — Install Counterweight (Without Hydraulic Removal Option)

Miscellaneous—Machine Assembly Install Counterweight (Without Hydraulic Removal Option) IMPORTANT: DO NOT attempt to remove or install counterweight with the track gauge in the narrow transport position. Before removing or installing the counterweight, the track gauge must be widened to the work position. See Track Gauge Transport Position Adjustment. (See Section 2-2.) NOTE: Counterweight installation procedure must be performed with the machine located on a level surface. 1. Park machine on a level surface. 2. Rotate upperstructure 90°. lower front attachment to the ground. 3. Stop engine. CAUTION: Prevent possible injury from unexpected counterweight movement.

DO NOT go directly under machine counterweight. To remove or install counterweight hardware, go under machine entering from the area on either SIDE of the counterweight. Clear everyone from the area before removing or installing the counterweight. T8172AC —UN—20FEB94 4. Remove the rear bottom covers from each side of the machine. A—Tie Bolt (2 used) B—Washer (4 used) C—Slotted Nut D—Counterweight E—Lock Pin 5. Open engine hood. CAUTION: The approximate weight of the counterweight is 8210 kg (18,100 lb). Use an adequate lifting device when lifting the counterweight. 8. Tighten each tie bolt (A) to 2400 N·m (1,770 lb-ft).

Specification Bolt—Torque.......................................................... 2400 N·m (1,770 lb-ft) Specification Counterweight—Weight............................................ 8210 kg (18,100 lb) NOTE: Tighten or loosen tie bolts (from torque) to align lock pins.) 6. Lift counterweight into position. 9. Install lock pins (E). 7. Install parts (A—C) to attach counterweight to the machine. Continued on next page T1559,VV757 -19-22MAR00-1/2 4-2-9 060313 PN=141