Miscellaneous—Operational Checkout Gauges, Monitor, And Relay Checks 2 1 6 DISPLAY SELECT 5 SET WORKMODE 4 3 T141361 —UN—04MAY01 1— Engine Coolant Temperature Gauge 2— Fuel Gauge 3— Alternator Voltage Indicator 4— Engine Oil Pressure Indicator 5— Dig Mode Indicator 6— Monitor Display NOTE: Monitor buzzer is not checked during this procedure. NOTE: If engine coolant temperature is below 30°C (86°F) engine coolant temperature gauge needle may not move to the right. Run engine a few minutes to warm coolant before check. Engine OFF. Key switch ON. Does battery relay click? Do engine coolant temperature gauge (1) and fuel gauge (2) needles move to the right? YES: Go to next check.
Do all monitor indicators light and after seconds only the alternator voltage indicator (3), engine oil pressure indicator (4), and dig mode indicator (5) remain lit? NO: Check monitor fuses 1 and 7 in the fuse box. Does monitor display (6) show 888888.8 for 2—3 seconds, then indicate machine hours? NO: Check and replace bulb if any bulb fails to light. Go to your authorized dealer. VD76477,0000057 -19-12SEP12-3/27 Operator Station Checks—Engine On Continued on next page VD76477,0000057 -19-12SEP12-4/27 4-3-2 060313 PN=144