SECTION 4 OPERATING Page 54 LOADER TECHNIQUES DO NOT try to pick up objects too large to handle (Fig. 4.71). It may damage the bucket and linkage. Wrong Fig. 4.71. Picking up Large Objects with Multi-Purpose Bucket 4.19. ECONOMICAL OPERATION OF MACHINE Fuel consumption during operation of a loader depends on many factors as: engine characteristics, load, terrain, operator’ s skill and experience, manner of operation. A relatively conclusive indicator of fuel consumption is the quantity of moved material per unit of consumed fuel. To reach the most favorable value of this ratio observe the following principles of loader operation:
avoid long distance transporting of material, loading and pushing of material must be performed in a gear which ensures maximum drawbar pull (at high torque converter efficiency), take care to fill the bucket correctly during operation, use 1 st and 2 nd gear, avoid maximum speed of the engine, avoid stopping machine due to stall of the engine. 4.20. QUICKCOUPLING The quickcoupling is a device installed on the boom, designed for quick fastening and removal of the mounted equipment such as a bucket, grapple, forklift, dozer blade etc.
The quickcoupling is an angle section frame fitted with an equipment bracket and two mounting pins controlled by two hydraulic cylinders (Refer to QUICKCOUPLING, Section 6). The hydraulic hoses supplying the cylinders with oil are equipped with quick disconnect couplers. The quickcoupling tool carrier is mounted on the boom with pins. It can be fitted on machines equipped with a 3-spool control valve or 2-spool control valve along with a pilot solenoid valve The hydraulic schematic of a 520 C loader equipped with a 3-spool control valve is shown in Section 6.
The hydraulic schematic of a 520C loader equipped with a 2-spool control valve and a pilot solenoid valve (standard and upgraded version) is shown in Section 6. OM515C520C99/1E DRESSTA