Komatsu — 5.4.4. VISCOSITIES

MAINTENANCE SECTION 5 Page 9 5.4. LUBRICATION 5.4.1. WHEN SHIPPED This Wheel Loader has been lubricated at the factory for operation in an air temperature range of +21 [ ° C] to -23 [ ° C]. If this machine is to be operated above or below this range, change to the correct lubricants. Unless an exception is shown below, all lubricants can be used (within above temperature range) until regular scheduled (normal) change intervals occur. Refer to "SERVICE CHART", Section 5.3, for the scheduled (normal) change intervals and to Chart 2 for the proper oil grades for ambient temperatures. 5.4.2.

WHEN SERVICED The life and performance of a wheel loader and its equipment depends on the service that it is given. Proper lubrication is an important part of the maintenance service. Thorough lubrication service performed at the specified intervals will aid in prolonging the life of a loader and its equipment and in reducing operating expense. The type of work being done, load, ground and weather conditions are all factors to consider in frequency of lubrication. The scheduled intervals between the lubrication periods shown in the "SERVICE CHART" are approximate, based on average operating conditions.

It may be necessary to lubricate after shorter working periods under severe operating conditions such as extreme dust, low engine temperatures, intermittent operation, excessively heavy loads with high oil temperatures, or when diesel fuel with a high sulfur content is used. However, the time intervals between lubrication periods must never exceed those indicated in this manual. 5.4.3. LUBRICANT SELECTION The selection of the proper type (specification) and the grade (weight or viscosity) of lubricant is important. Many tests have been made to determine the correct lubricants for this wheel loader and its equipment. The resulting recommendations are included in section 5.4.5 and 5.4.6.

5.4.4. VISCOSITIES During cold weather, base the selection of a crankcase lubricating oil viscosity on the lowest anticipated temperature for the day to make starting easier. For hot weather operation, base the selection on the highest anticipated temperature. Refer to the "REFILL SPECIFICATIONS AND CAPACITIES", Section 5.4.5, Chart 2. DRESSTA OM515C520C99/1E