Komatsu — 5.10.4. BATTERIES

MAINTENANCE SECTION 5 Page 29 5.10. ELECTRICAL SYSTEM 5.10.1. ELECTRIC WIRES WARNING! Before working on the electric system, disconnect the master electrical switch and remove the key. All terminals must be clean and fastened securely. Repair or replace all broken wires immediately. Surface under all terminals must be clean and good electrical connections must be established after reassembly. Also all clips must grip cables tightly to prevent vibrations and rapid cable wear. All clips and straps must be closed in a workmanlike manner, so as not to damage the insulation. 5.10.2. CIRCUIT BREAKERS AUTOMATIC CIRCUIT BREAKERS Electrical circuits are protected by automatic reset circuit breakers.

They are located under the instrument panel. In the event of a "short circuit" or "ground", the circuit breaker will open before damage occurs and will continue to open and close until the trouble clears or is corrected. When replacing use circuit breakers of the same amps. To replace circuit breaker carry out as follows: 1. Remove two screws and lock washers securing the breaker to the instrument panel. 2. Remove the circuit breaker and replace it. 3. Reassembly in the reverse order. 5.10.3. BULB OR LAMP REPLACEMENT FRONT AND REAR ROAD LIGHTS Remove the sealed beam unit and replace the bulb with a new one.

STOP AND PARKING LIGHTS Raise the rubber retainer lip and remove the sealed beam or the bulb depending on the type of lamp. Install a new sealed beam or bulb of the same type. INSTUMENT PANEL LIGHTS Reach under the instrument panel and turn the bulb holder. Pull the holder free. Press down on the bulb in the holder, turn counterclockwise and pull it free of the socket. Replace with a bulb of the same type. Place a new bulb into the holder, press down and turn clockwise. Insert the holder into the instrument panel and turn until secure. 5.10.4. BATTERIES A loader is equipped with two twelve volt maintenance free batteries.

They are located in the battery compartment on the left-hand side of the rear main frame. (In CE version they are located in the counterweight recess). Never allow the battery to stand on concrete, ground or a metal support unless proper insulation is provided. A wooden platform or board is sufficient insulation. Be sure the battery is fastened securely to avoid damage from vibration. DRESSTA OM515C520C99/1E