Komatsu — 5.14.1. CHECKING THE RESERVOIR OIL LEVEL

SECTION 5 MAINTENANCE Page 42 ENGINE Fig. 5.33. Venting the Fuel System 1. Bleeder Plug 2. Hand Pump 5.14. HYDRAULIC SYSTEM GENERAL Before removing any components from the hydraulic reservoir, clean the top surface of the reservoir and the components to be dismantled with a commercial cleaning solvent. WARNING! Before servicing the machine, be sure the engine is off, the bucket is lowered, the transmission direction lever is locked in neutral (N), the parking brake is applied, the electric system master switch is off, and the keys are removed. WARNING! This machine has a pressurized hydraulic reservoir.

Loosen the filler cap slowly to relieve the pressure before disassembly of any hydraulic system component. Do not overfill. WARNING! Always lock the frame halves together with the frame locking bar and pins before performing service near the machine's articulation pivot. 5.14.1. CHECKING THE RESERVOIR OIL LEVEL 1. Park the machine on level ground. Lower the bucket to the ground. 2. Stop the engine and apply the parking brake. 3. Check the oil level sight gauge. If the ball is not floating in the sight gauge (Fig. 5.34), oil must be added. WARNING! This machine has a pressurized hydraulic reservoir. Loosen the filler cap slowly to release the pressure.

It is obligatory before disassembly of any hydraulic system components. OM515C520C99/1E DRESSTA