Komatsu — 4.18.2. DIGGING, CLEARING AND LEVELING

OPERATING SECTION 4 Page 47 LOADER TECHNIQUES 4.18.2. DIGGING, CLEARING AND LEVELING 1. When digging or excavating lower the bucket to the ground. Adjust the angle of the cutting edge when the machine moves forward (Fig. 4.52). Change inclination of the angle of the cutting edge and cutting depth using the boom and bucket control levers depending on bucket filling. Establish the parameters to obtain the best bucket filling. When the bucket is full, roll it back and raise it clear off the ground and carry the load to the desired dump area. Fig. 4.51. Digging or Excavating Clearing an excavation (Fig.

4.52) may be performed with the bucket partly in the dump position by disposing of the material carried in the bucket. It is recommended to clear an excavation a little above the ground level because after compaction the ground will be level. Approach an excavation at the right angle and stop the front wheels at a safe distance from the edge of the excavation. Fig. 4.52. Filling an Excavation WARNING! Never backdrag, push any objects (trees, rocks, etc) with the bucket in the utmost dump position as due to unfavorable distribution of forces a serious damage to loading mechanism can result. It is particularly unfavorable when operating with boom raised. DRESSTA OM515C520C99/1E