Komatsu — Seat Adjustment

Operator Cab and Controls - Section 32 9/11 OM3247 Page 32-10 OPERATOR’S SEAT The operator's seat provides a fully adjustable cushioned ride for driver comfort and easy operation. 8. Suspension Dampener - Adjust suspension dampener (8) to obtain the desired stiffness of the adjustable shock absorber. Move the lever upward to stiffen the absorbency of the shock. Move the lever downward to soften the ride. Five detented settings are available. NOTE: This seat contains a fixed rate shock absorber in addition to the adjustable shock absorber that is controlled by the suspension dampener.

Seat Belts On both driver and passenger seats, check the seat belt fabric, buckle, all belt retractors and hardware for damage or wear. Replace any worn or damaged parts immediately. Even if there are no signs of damage, replace both driver and passenger seat belts 5 years after seat belt manufacture, or every 3 years after start of use, whichever comes first. The passenger seat belt date of manufacture label is sewn into the seat belt near the buckle. The driver seat belt date of manufacture label is sewn into the shoulder harness belt, near the retractor end. Seat Adjustment The following adjustments must be made while sitting in the seat. Refer to Figure 32-5. 1.

Headrest - Move headrest (1) up, down, fore, or aft to the desired position. 2. Seat Height - Push and hold switch (2) to adjust the height of the seat. Release the switch when the desired height is reached. Optimum ride height is obtained when the suspension is at the middle of its stroke. To properly adjust, raise the seat to its highest level. Then, lower the seat approximately 51 mm (2 in.) to the middle of the suspension stroke. 3. Lumbar Support - Move dial (3) to adjust the lumbar support to the desired position. 4. Armrest Tilt - Rotate adjusting knob (4) until the armrest is in desired position. 5.

Seat Belt - The operator must always have seat belt (5) buckled and properly adjusted when- ever the truck is being operated. 6. Backrest Recline - Lift handle (6) to select the desired backrest recline. Release the handle to set the position. FIGURE 32-5. OPERATOR’S SEAT ADJUSTMENT CONTROLS 7. Fore/Aft Location of Seat - Lift and hold lever (7) and move the seat to a comfortable height. Release the lever to lock the height adjustment. 1. Headrest 2. Seat Height 3. Lumbar Support 4. Armrest Tilt 5. Seat Belt 6. Backrest Recline 7. Fore and Aft 8. Suspension Dampener