John Deere Omar287594 — Converting Category 4 Convertible Quick Coupler Lower Hooks

Hitch Detaching Implement from Quick Coupler 1. Raise both latch levers (A) with implement raised. 2. Disconnect hydraulic hoses and electrical connections. 3. Lower implement to ground. Continue lowering quick coupler until hooks clear implement hitch pins. RXA0078885 —UN—08FEB05 NOTE: For tractors equipped with Independent Link Suspension induce tractor leveling with engine operating: Depress clutch Put transmission shift lever in gear for four seconds Move shift lever to NEUTRAL position Repeat until suspension is level Coupler Latch Handle A—Latch Lever 4. Carefully drive tractor away from implement.

OURX935,000045A ­19­20SEP07­1/1 Converting Category 4 Convertible Quick Coupler Lower Hooks A CAUTION: Use proper lifting device when converting coupler. Failure to do so can result in personal injury. RXA0085785 —UN—10JAN06 C G E NOTE: A second person is recommended to align components during conversion. B F If category 4 lower hooks are to be used on category 3 implements, bushings are needed over the category 3 pins; these bushings can be purchased through your John Deere dealer. Converting Lower Hooks D NOTE: Lower hooks are not marked for left­hand or right­hand side. Do not move lower hooks from one side to the other.

A—Quick Coupler Frame B—Cap Screw C—Retainer D—Pin E—Lower Hook F—Category 3 Hook G—Category 4N Hook 1. Support quick coupler frame (A). 2. Remove cap screw (B). 3. Remove retainer (C), then pin (D). 5. Install lower hook, with desired end facing out. Using a reverse motion of removal, rotate it up and in. NOTE: Because lower hook (E) has a category 3 hook (F) on one end and a category 4N hook (G) on the opposite end, it is used for both category 3 and 4N simply by turning it end for end. 6. Install pin, retainer and cap screw. Tighten to torque. Specification Lower Hook Cap Screws—Torque................................... 100 (74 lb­ft) 4.

Remove lower hook by rotating it down and to the rear of the coupler, then sliding it out at the front of the coupler. OURX935,0000454 ­19­02JAN08­1/1 50­19 122208 PN=138