John Deere Omar287594 — Using Hydraulic Spray Pumps

Remote Hydraulic Connections Examples Using Load­Sensing Hydraulic System— Power­Beyond E D E D A A B B C C G E D F RXA0085800 —UN—10JAN06 A A B B C C Four Examples of Load­Sensing Hydraulic System Power Beyond A—Pressure Line B—Return Line C—Load­Sense Line D—Control Valve E—Cylinder F—Pressure­Compensated Flow Valve G—Hydraulic Motor Upper Left —Control valves with a load­sense provide a load­sense signal to hydraulic system and can be operated manually or by solenoids. NOTE: System will maintain a maximum pressure of 20000 kPa (200 bar) (2900 psi) as long as power­beyond hoses are connected. Upper Right —Control valve directs oil into extend or retract circuits.

Connect load­sense line to circuit requiring pressure. An example is a wagon lift cylinder with load supported by mechanical stops in full down position. Load­sense signals pump when increased pressure is needed. Pressure remains low when not needed. An example is a folding implement, where pressure is needed to extend or retract cylinders. Lower Right —Pressure­compensated flow control valve is used to regulate hydraulic motor speed. Connect load­sense line to pressure line after control valve. IMPORTANT: Circuit allows cylinder "leak­down" through load­sense line (C). If leakage is not acceptable for operation, use Example 3. NOTE:

Motor speed can fluctuate when other functions cause system pressure change. Minimize fluctuations by installing a pressure­compensated flow control valve. Lower Left —Control valve directs oil into extend or retract circuits, either requiring high pressure. Connect load­sense line to pressure line before control valve. OURX935,000008D ­19­15JAN08­1/1 65­2 122208 PN=157