Performance Ballasting Measuring Wheel Slip—Manually NOTE: Tractors equipped with optional radar unit can automatically determine the percentage of wheel slip. Radar must be calibrated correctly. (See CommandCenter section). 1. Mark a rear tire. RW26776 —UN—12JAN00 2. Mark a starting point on the ground with the tractor moving and implement lowered in the ground. 3. Follow tractor and mark the ground again where marked tire completes 10 full revolutions. 4. Repeat procedure with implement raised at the same working speed. Count revolutions between same two marks. 5. Use second count and chart to determine slippage. NOTE:
8—12% is ideal for tractors with MFWD engaged (10—15 percent for twowheel drive tractors). RW26777 —UN—13JAN00 6. Adjust ballast or load to give correct slippage. NOTE: Available horsepower is greatly reduced when wheel slip drops below minimum percent. Wheel Slippage Chart Wheel Revolutions (Step 4) % Slip Result 10 0 Remove Ballast 91/2 5 Remove Ballast 81/2 15 Add Ballast 9 10 Correct Ballast 8 20 Add Ballast 71/2 25 Add Ballast 7 30 Add Ballast BB92646,0000061 1915JUL051/1 7518 122208 PN=195