John Deere Omar287594 — Recommended Pressures—Group 42

Front Wheels, Tires, and Treads Tire Inflation Pressure Guidelines Check tire inflation pressure at least every two weeks, while tires are cool, using an accurate dial or stick­type gauge having 10 kPa (0.1 bar) (1 psi) graduations. determining rear axle weight. If tractor is equipped with both a front and rear­mounted implement, raise both implements. NOTE: Use a special air­water gauge and measure with valve stem at bottom if tires contain liquid ballast. Managing Tire Inflation Pressures IMPORTANT: Integral implements transfer significant weight to rear axle. Include this added weight when determining correct inflation pressures.

Correctly inflated radial tires will show a deflection of the sidewall. This is normal and will not harm the tire. Inflation pressures less than 80 kPa (0.8 bar) (12 psi) should be monitored frequently because of the increased risk of low pressure air leaks. Tractors operating with a loader should increase front tire pressures 30 kPa (0.3 bar) (4 psi) above the values listed to compensate for weight transfer. NOTE: Bead slip can be experienced in high­traction conditions. Increasing the inflation pressure will help but will reduce traction.

Tractors operating on steep side slopes or furrow plowing should increase rear tire pressures 30 kPa (0.3 bar) (4 psi) above the values listed for base pressures 80 kPa (0.8 bar) (12 psi) and above to compensate for lateral weight transfer. For base pressures below 80 kPa (0.8 bar) (12 psi), pressure should be increased by 30 percent. Maximum tire pressure is specified on tire sidewall. Determine correct tire pressure by weighing tractor using the following procedure: Front axle weight with implement lowered Tractors with heavy hitch­mounted implements require increased rear tire inflation pressures to carry the increased weight during transport.

Rear axle weight with implement raised Set tire inflation pressures according to weight measured. Ballasting and tire inflation pressure may need to be adjusted when operating conditions change. Reduce pressures to correct pressure for towed implement operation. Tractors with heavy hitch­mounted implements that require additional front cast­weights to maintain steering stability also require increased front tire inflation pressure to carry the increased weight. NOTE: If tractor is equipped with front­mounted implement, raise implement when determining front axle weight and lower implement when OURX935,0000693 ­19­23NOV07­1/1 80­4 122208 PN=199