John Deere Omar287594 — MFWD Steering Stop Settings

Front Wheels, Tires, and Treads 1500 MFWD Axle Toe­In Adjustment NOTE: Timing mark (B) on adjustment screw (A) is factory set at zero toe­in. 1. Loosen cap screws (E and F) on the split end (H) of the clamp (G). NOTE: Turn Adjustment screw a maximum of 90° to adjust the toe­in up to 2 mm (3/32 in.). Considering set screw may be turned either left or right, total toe­in adjustment is a total of 4 mm (3/16 in.). RXA0087842 —UN—16MAR06 2. Adjust toe­in, then measure wheels as specified in MFWD And Independent Link Suspension Toe­In Check to verify toe­in is correct. Specification Cap Screws—Torque....................................................... 310 (229 lb­ft) 3.

Tighten cap screws to torque. 1500 MFWD Axle Toe­In Adjustment A—Adjustment Screw B—Timing Mark C—Upper Clamp Cap Screw (Solid End) D—Lower Clamp Cap Screw (Solid End) E—Upper Clamp Cap Screw (Split End) F—Lower Clamp Cap Screw (Split End) G—Clamp H—Split End Lower Boot NOTE: If all four cap screws are loosened, tie rod may drop down allowing lower boot (I) to rub on the lower clamp. To avoid premature wear on lower boot, tie rod must be centered between the upper and lower clamps. Cap screws on the solid end of the clamp must be tightened before cap screws on the split end of the clamp. Use a crisscross method to tighten cap screws. If all four screws are loosened:

Tighten clamp solid end cap screws (C and D). Tighten clamp split end cap screws (E and F). OURX935,000050F ­19­03JAN08­1/1 Independent Link Suspension Toe­In Adjustment CAUTION: For tractors equipped with front hitch, avoid possible personal injury and equipment damage. DO NOT use the front hitch to lift the tractor. Use correct lifting equipment. RXA0056534 —UN—18OCT01 1. Make sure axle is centered. 2. Loosen clamp bolts (A) on both tie rods. 3. Rotate inboard pin (B) using the wrench flats (C). One full revolution of both pins changes toe­in approximately 20 mm. 4. Tighten clamp bolts (A) on both tie rods.

Clamp Bolt—Specification Bolt—Torque.................................................................... 125 (90 lb­ft) OURX935,0000759 ­19­23NOV07­1/1 80­10 122208 PN=205