John Deere Omar287594 — Eight Position Wheel Settings

Front Wheels, Tires, and Treads Independent Link Suspension Steering Stop Settings E B 1 2 3 1 2 3 A E F 2 3 RXA0053863 —UN—17OCT01 RXA0064851 —UN—17JAN03 D C A—Retaining Cap Screw B—Wrench C—Bleed Screw D—Rod Guide E—Steering Stop Position Marks F—Outer Flange CAUTION: For tractors equipped with front hitch, avoid possible personal injury and equipment damage. DO NOT use the front hitch to lift the tractor. Use correct lifting equipment. Specification Retaining Cap Screw—Torque ........................................ 125 (90 lb­ft) 1. Determine correct steering stop position for tire size and tread setting. 7. Tighten bleed screw (C) and jam nut.

Bleed Screw and Jam Nut—Specification Screw—Torque................................................................ 40 N∙m (30 lb­ft) Jam Nut—Torque............................................................. 15 N∙m (12 lb­ft) 2. Remove cap screw (A) and wrench (B) on axle housing. 3. Loosen bleed screw (C) and jam nut. 8. Repeat procedure on opposite side of axle housing. NOTE: To check a steering stop position of zero, insert wrench as shown in right­hand illustration, the wrench will be flush with outer flange (F). IMPORTANT: Settings allow 25 mm (1 in.) minimum clearance at maximum turn and full oscillation. Fenders may deflect against side frame during turn.

Clearance and interference must be checked under full oscillation and full turn. 4. Check current rod guide (D) position using position marks (E) on wrench. 5. Turn rod guide (D) using wrench (B) to adjust distance to correct steering position. 9. Verify clearance by turning fully left then fully right. 6. Adjust guide minimally to reinstall wrench and retaining cap screw (A). OURX935,000067E ­19­23NOV07­1/1 80­12 122208 PN=207