Safety Support Machine Properly Always lower the attachment or implement to the ground before you work on the machine. If the work requires that the machine or attachment be lifted, provide secure support for them. If left in a raised position, hydraulically supported devices can settle or leak down. Do not support the machine on cinder blocks, hollow tiles, or props that may crumble under continuous load. Do not work under a machine that is supported solely by a jack. Follow recommended procedures in this manual. TS229 —UN—23AUG88 When implements or attachments are used with a machine, always follow safety precautions listed in the implement or attachment operator’s manual.
DX,LOWER 1924FEB001/1 Service FrontWheel Drive Tractor Safely When servicing frontwheel drive tractor with the rear wheels supported off the ground and rotating wheels by engine power, always support front wheels in a similar manner. Loss of electrical power or transmission hydraulic system pressure will engage the front driving wheels, pulling the rear wheels off the support if front wheels are not raised. Under these conditions, front drive wheels can engage even with switch in disengaged position. L124515 —UN—06AUG94 OUMX005,0001690 1908NOV071/1 Remove Paint Before Welding or Heating Avoid potentially toxic fumes and dust.
Hazardous fumes can be generated when paint is heated by welding, soldering, or using a torch. Remove paint before heating: Remove paint a minimum of 100 mm (4 in.) from area to be affected by heating. If paint cannot be removed, wear an approved respirator before heating or welding. If you sand or grind paint, avoid breathing the dust. Wear an approved respirator. If you use solvent or paint stripper, remove stripper with soap and water before welding. Remove solvent or paint stripper containers and other flammable material from area. Allow fumes to disperse at least 15 minutes before welding or heating.
TS220 —UN—23AUG88 Do all work in an area that is well ventilated to carry toxic fumes and dust away. Dispose of paint and solvent properly. Do not use a chlorinated solvent in areas where welding will take place. DX,PAINT 1924JUL021/1 0512 122208 PN=22