John Deere Omar287594 — Rear Drive Wheel — Installing

Rear Wheels, Tires, and Treads Rear Wheel, Tire and Tread Guidelines A RXA0056703 —UN—29AUG01 B A—Fenders B—Centerline To provide a wider range of tread settings, wheels may be switched side to side. This provides either dished in or dished out condition. Always maintain correct direction of tire rotation. With sway blocks in upper position (sway allowed), minimum distance between tires must be 1090 mm (43 in.) to prevent interference. CAUTION: Prevent personal injury and tractor instability. Never operate with single tires having tread width less than 1520 mm (60 in.). Do not exceed 2800 mm (110 in.) between single tires for pulling heavy loads.

Check for adequate clearance between implement and rear tires. IMPORTANT: Tires must have at least 25 mm (1 in.) clearance with fenders (A). Distance between tires must be at least 1015 mm (40 in.) with tires equal distances from tractor centerline (B). Over inflating a radial tire reduces machine performance. Using the correct inflation pressures will result in optimum tractive performance. OURX935,0000493 ­19­15AUG08­1/1 Rear Drive Wheel Installing CAUTION: Avoid the possibility of personal injury. Never operate tractor with loose wheel bolts. NOTE: The wheel rim (A) has one tight fit hole smaller than the other holes.

One slot fit hole is 180° from the tight fit hole, for improved wheel centering. RXA0056891 —UN—11SEP01 Install and hand tighten bolt in the tight fit hole (B). Install and hand tighten bolt in the slot fit hole (C). Install and hand tighten remaining bolts. Tighten all bolts to torque. Specification Sleeve Bolts—Final Torque ............................................. 600 (445 lb­ft) Heavy Duty Cast Wheel Shown Tighten all bolts to torque again. A—Wheel Rim B—Tight Fit Hole C—Slot Fit Hole Drive tractor 100 meters (100 yd) and torque bolts. Tighten again at 3 HOURS , 10 HOURS , and DAILY for the first week of operation. OURX935,0000494 ­19­15AUG08­1/1 81­5 122208 PN=222