John Deere Omar287594 — Rear Drive Wheel Tread Settings for Single Wheels

Rear Wheels, Tires, and Treads Adjusting and Tightening— Heavy­Duty Dual Wheels (10 or 12 Bolt Hubs) RXA0091580 —UN—20NOV06 RXA0097661 —UN—03APR08 Heavy­Duty Hub­10 Bolt (120 mm Axle) Heavy­Duty Hub 12 Bolt (120 mm Axle) A—Cap Screws CAUTION: Avoid personal injury. Never run the engine with transmission in gear when adjusting wheels. Wheels on the ground could pull supported wheels off jackstands. 5. Tighten bolts (1—10) or (1—12) in numerical order to final torque specifiation. Specification Cap Screws (A)—Final Torque........................................ 610 450 lb­ft Never operate tractor with a loose rim, wheel, or hub. IMPORTANT:

Repeat torquing pattern until ALL bolts maintain the proper torque. Failure to follow procedure could result in damage to equipment and may result in personal injury. IMPORTANT: Tractors are equipped with 12 bolt heavy­duty wheels and 10 or 12 bolt hubs. Numbers indicating proper torquing sequence are cast into wheel hub. Carefully follow procedure. Failure to do so could lead to wheel hub damage. 6. Using a star shaped pattern, torque all wheel to hub cap screws (A) as needed to maintain torque. Specification Cap Screws (A) Initial Torque—Initial Torque......................................................

405 300 lb­ft Cap Screws (A) Final Torque—Final Torque.............................................................................. 610 450 lb­ft IMPORTANT: Clean any paint, grease, film, rust or debris from axle shafts prior to positioning and installing wheel hubs and sleeves. DO NOT apply any lubricant to cap screws or threads. 1. Raise the tractor on level ground and support tractor with jackstands. 7. Drive tractor a minimum of 100 meters (110 yd) and tighten bolts in numerical order until bolts maintain torque of 610 (450 lb­ft). 2. Loosen (without removing) sleeve bolts (1—10) or (1—12) just enough to move wheel. IMPORTANT: Do not loosen or remove the two allen head screws.

Doing so could result in wheel jamming or damage. IMPORTANT: If tractor is operated with wheel sleeve loose for 4­5 hours, it is necessary to replace sleeves. NOTE: Adjusting tool is not compatible with heavy­duty wheel hub. 8. Torque bolts after working 3 HOURS , 10 HOURS, and DAILY during the first week of operation. NOTE: Continue to check torque a minimum of weekly if used for normal scraper operations. 3. Move wheel to desired position. 4. While making sure wheel is perpendicular to axle, tighten bolts (1­10) or (1—12) in numerical order to torque initial specification. Specification Cap Screws (A)—Initial Torque .......................................

405 300 lb­ft OURX935,0000496 ­19­15AUG08­1/1 81­7 122208 PN=224