John Deere Omar287594 — Freeing a Mired Machine

Transport apply wheel brakes at the same time as tow vehicle. Turn key switch to ”START position”, cranking engine for 10­15 seconds, then release to ”RUN” position. CAUTION: Avoid possible injury. If park brake starts to drag repeatedly even after performing Step 8, system is unable to maintain sufficient pressure to keep park brake released. Signal tow vehicle driver to stop immediately, as park brake may engage suddenly. Person in towed tractor should apply wheel brakes at the same time. 11. After tractor has reached service area, depress brake pedals to bring tractor to a complete stop before switching key to position. 12.

Move fuses from fuse # 10 location back to fuse #18 location and from fuse #11 location back to fuse # 24 location. 10. Every 30 minutes, or if STOP light starts flashing and warning horn sounds continuously and an associated message appears on the CommandCenter display, or if park brake drag is felt, signal tow vehicle driver to stop immediately. Person in towed tractor should 13. Re­install plastic fuse isolator to F10 and F11 fuse locations. Install access panel. OURX935,000053F ­19­27AUG08­2/2 Transporting with Ballast CAUTION: Avoid possible injury or equipment damage when transporting heavy rear­mounted implements. Drive slowly over rough ground, regardless of how much ballast is used.

Add weight to front end if needed to maintain stability and steering control. Heavy pulling and heavy rear­mounted implements tend to lift front wheels. Use implement code in implement operator’s manual to determine the minimum number of front weights required. RF30435,0000034 ­19­04SEP07­1/1 85­5 122208 PN=234