John Deere Omar287594 — Lubricating Hitch Components

Daily or 10 Hour Service Checking Transmission/Hydraulic Oil Level B RXA0098554 —UN—16JUN08 A A—Sight Glass B—Filler Cap Park tractor on level ground. Sight glass observations will be significantly higher with hotter oil temperatures and lower with colder oil or if engine has not run long enough. Operate engine at approximately 1000 rpm for at least one minute. Before checking oil level, stop engine and wait an additional three minutes for oil to settle back into differential case. Observe oil level in sight glass (A). Oil level should be between the marks on the glass. Optimum level is at the top mark. IMPORTANT:

Change oil in clean oil reservoir immediately if oil is contaminated with water. IMPORTANT: Oil level above the top mark on sight glass can result in power loss and heat generation during transport. NOTE: Oil temperature should be approximately 45° C. See Changing Display Functions in the CommandCenter section to determine oil temperature. If oil level is below the lower mark, remove filler cap (B) and add hydraulic oil. Tractor should be on level ground with hitch in the lowered position and engine stopped when checking oil level. OURX935,00002AE ­19­19JUN08­1/1 Draining Air Brake Tank RXA0097298 —UN—19FEB08 RXA0098555 —UN—16JUN08 A—Air Tank Drain Cable B—Tube C—Lever NOTE:

Air brake tank should be drained before beginning daily operations. Air tank is designed in such a way that when air tank drain cable is pulled, lever (C) opens valve allowing water to drain. Tank is designed with tube (B) near the bottom of tank to collect water that accumulates Pull Air Tank Drain Cable (A) at the back of tractor to drain air brake tank. OURX935,00002B0 ­19­25JUN08­1/1 100­2 122208 PN=257