John Deere Omar287594 — Checking Coolant Level (Coolant De-aeration Tank)

Initial 100 Hour Service Changing Engine Oil and Filter IMPORTANT: Use of diesel fuel with sulfur content less than 0.10% (1000 ppm) is strongly recommended. Refer to Fuel, Lubricants and Coolant section for more information on oil change intervals. If fuel sulfur level is 0.20 0.50% (2000 to 5000 PPM), regular interval of 250 hours between oil changes should be reduced to 150 hours. See Changing Engine Oil and Filter in the 250 Hour Service Section. NOTE: INITIAL oil and filter change is 100 hours maximum of operation. *SCHEDULED interval (250 hours) can be extended to 375 hours if John Deere PLUS 50 oil and John Deere filter are used.

OURX935,0000333 ­19­19JUN08­1/1 Checking Coolant Level (Coolant De­aeration Tank) RXA0078826 —UN—04FEB05 TS281 —UN—23AUG88 Pressurized Cooling System can Cause Serious Burns A—De­aeration Tank Cap CAUTION: Explosive release of fluids from pressurized cooling system can cause serious burns. If tank is empty and recovery tank has been kept at least full cold, this indicates a leak that prevents system from recovering coolant from recovery tank. Shut off engine. Only remove cap when cool enough to touch with bare hands. Slowly loosen cap to first stop to relieve pressure before removing completely.

If recovery tank level does not change when engine is being warmed up, this is a sign of a leak or of a very low coolant level in the pressurized circuit. 3. Check de­aeration tank level. Tank will not be full of coolant when cap is removed. 1. Raise hood. 2. Slowly turn de­aeration tank cap (A) to relieve pressure. Remove cap. 4. Add coolant, as specified in Fuel, Lubricants and Coolant section. NOTE: When inspecting tank, if it is at least half full, do not add additional coolant. 5. Reinstall de­aeration tank cap. OURX935,0000334 ­19­19JUN08­1/1 101­1 122208 PN=260