John Deere Omar287594 — Testing Coolant

750 Hour Service Testing Coolant RXA0078826 —UN—04FEB05 TS281 —UN—23AUG88 A—De­aeration Tank Cap CAUTION: Explosive release of fluids from pressurized cooling system can cause serious burns. NOTE: Follow instructions on back of reader card in test strip pack when testing coolant. Shut off engine. Only remove cap when cool enough to touch with bare hands. Slowly loosen cap to first stop to relieve pressure before removing completely. 4. Add TY26603 COOL­GARD II Coolant Extender available from your John Deere dealer as indicated by the color matrix on reader card in test strip pack. If tank is too full, drain a small amount of coolant from system before extender is added. 1. Raise hood. 2.

Slowly turn de­aeration tank cap (A) to relieve pressure. Remove cap. NOTE: Cap gasket should be visually checked for sealing effectiveness. A good functioning gasket should have the imprint of the mating surface with no apparent scratches or leak paths. NOTE: De­aeration tank will not be full of coolant when cap is removed. When inspecting tank, if it is at least half full, do not add additional coolant. 5. Install de­aeration tank cap and lower hood. 3. Test coolant using TY26605 COOL­GARD™II 3­way test strips available from your John Deere dealer. COOL­GARD is a trademark of Deere & Company OURX935,00002D6 ­19­11DEC08­1/1 104­3 122208 PN=276