John Deere Omar287594 — Cleaning Radiator, Coolers and Air Conditioning Condenser

General Services Servicing and Connecting Snap to Connect STC® Fittings CAUTION: Do not disconnect STC fitting when under pressure. Failure to relieve pressure before disconnecting fitting may result in personal injury, damage to equipment or both. RXA0080095 —UN—31MAR05 NOTE: Snap to Connect fittings are used on steel lines, hose connections and come in a variety of sizes. JDG1885 STC tool (A) is designed as a spacer to move release ring (B) inward which releases retaining ring (C). JDG1885 STC tool can be purchased through your John Deere dealer. IMPORTANT: Do not use tool to pry fittings apart. Prying with tool may damage fitting and tool.

A—JDG1885 STC Tool B—Release Ring C—Retaining Ring D—Female End (STC Fitting) E—O­Ring F—Backup Ring G—Male End (STC Fitting) 1. Insert correct STC tool between release ring and fitting. 2. Remove hose or line from connector. NOTE: If retaining ring (C), backup ring (F) or O­ring (E) are damaged, see your John Deere dealer for replacement kit and replace all three parts. 3. make sure that female end (D) and male end (G) are clean and free of contaminates. Before connecting Snap to Connect Fitting: 4. make sure that release ring (B) is on male end fitting. 5. Push fitting halves together until a definite snap and solid stop is felt. 1. Check mating surfaces for nicks, scratches or flat spots. 2.

Check O­ring, backup ring and retaining ring for wear or damage. 6. Pull back on hose to make sure that fitting halves are locked together. STC is a registered trademark of Aeroquip Corporation OURX935,000030B ­19­12JUN08­1/1 Cleaning Radiator, Coolers and Air Conditioning Condenser A 1. Stop engine and raise hood. 2. Remove four cap screws (B) and front side shield (A). A—Front Side Shield B—Cap Screws RXA0074933 —UN—26MAY04 B Continued on next page OURX935,000030C ­19­12JUN08­1/2 110­1 122208 PN=298