John Deere Omar287594 — Hitch Troubleshooting

Troubleshooting Hitch Troubleshooting Symptom Problem Solution Insufficient transport clearance Center link too short Adjust center link Center link in wrong position Put center link of tractor in correct hole. See Hitch section Lift links too short Adjust lift links Implement not level Level implement Implement not correctly adjusted See implement operator’s manual Upper height limit not correctly set Adjust upper height limit in CommandCenter Independent Link Suspension leveling not functioning correctly or extended above level Induce leveling with engine operating by depressing clutch and putting transmission in gear for four seconds.

Repeat until suspension is in normal operating position Hitch fails to follow lever Malfunction in lever position sensor circuit or hitch position sensor See your John Deere dealer Poor position control Load/depth mix control on wrong position Adjust load/depth mix control in the CommandCenter to the left System is reset Enable system Malfunction in lever position sensor circuit or hitch position sensor See your John Deere dealer Independent Link Suspension leveling not functioning correctly during large draft changes Induce leveling with engine operating by depressing clutch and putting transmission in gear for four seconds.

Repeat until suspension is in normal operating position Hitch drops slowly Hitch rate­of­drop control not correctly set Adjust rate­of­drop through settings in CommandCenter Hitch fails to lift or lifts slowly Excessive load on hitch Reduce load Center link in wrong position Put center link in correct hole Hitch valve leak See your John Deere dealer Raise limit switch setting may be limiting lift Check settings in CommandCenter Implement will not operate at desired depth Lift links too short Adjust lift links Lack of penetration See implement operator’s manual Draft sensor failed See your John Deere Dealer Continued on next page OURX935,00003AD ­19­03SEP08­1/2 125­6 122208 PN=326